Nostalgia Electrics Beverage Dispenser CSD 250 User Manual

ICE S HOT D IS P EN SE R ꢀ

Model # CSD-250

Nostalgia Products Group LLC

1471 Partnership Dr.

Green Bay, WI 54304-5685

For Household Use Only

Read These Instructions Before Using This Unit!

Save These Instructions!

Visit Us Online at

Rev. 8/12/09

CLEANING

ABOUT YOUR ICE SHOT DISPENSER™ (Continued)

The ICE SHOT DISPENSER™ is easy to clean. Simply run hot water through the bottle stopper

by filling an empty bottle with hot water and allowing it to flow out through the spout. You can

also fill the ice bucket with hot water and allow it to flow through the aluminum coils. Dispose of

the water through the dispenser rear nozzle and plug.

Open your liquor bottle. Insert the

Bottle Stopper

Bottle Stopper into the bottleneck tightly.

To maintain the exterior finish of the ICE SHOT DISPENSER™, wipe down using a non abrasive

sponge or cloth with warm sudsy water and dry with a non abrasive clean cloth.

Flow Position

Turn the bottle upside down and insert the bottle

with the bottle stopper into the flow position

(above the dispenser) tightly.

Place a shot glass under the spout. Push the handle

forward. After about 60 seconds, your cold alcohol

shot will pour out while retaining all the

intensity of the flavor.

Spout

Handle

As the ice melts, water will collect in a reservoir

inside the dispenser unit. Place a cup under the

drain nozzle located at the back side of the dispenser,

and remove the nozzle plug. Allow to drain completely.

Replace the nozzle plug when reservoir is emptied.

Nozzle & plug